|
|
|
|
Assembly Instructions
 Insert the WATER PRESSURE CONTROL TUBE into the center of the
water barrel.
Fill the WATER BARREL with safe, uncontaminated water (preferably
non-chlorinated water) to approximately one inch from the brim of barrel.
Place the SPROUT BARREL onto the WATER BARREL.
Insert the assembled WATER TUBE into the sprout barrel.
It is important to align the connecting tubes carefully. If the tubes are not connected and aligned correctly, water pressure will be lost.
Place the LOWER TRAY (w/larger tabs up) into the SPROUT BARREL
and sprinkle seeds evenly. Cover with the UPPER TRAY
(w/larger tabs up).
Place the SPRINKLER on top of the WATER TUBE and cover
it with the TOP LID.
Plug the FreshLife Sprouter's cord into the appropriate outlet.
When your sprouts have grown to the desired height (varies with the type of seed used) they are ready to harvest.
To harvest your sprouts, remove sprouts from the SPROUT BARREL. The
roots will be attached to the SEED TRAY; you can pull them from the tray or cut them. Place sprouts in a bowl of clean water and agitate to separate the clumps of sprouts. After removing the sprouts from water, drain and place them in a storage container. Store it inthe refrigerator to maintain freshness. Most sprouts will remain fresh for 4-7 days when refrigerated, but make sure you check for the freshness before consumption.
Freshlife Cleaning Instruction.
a. Unplug the unit from the electric outlet
b. Disassemble the unit.
c. Wash the LID, SPLINKLER, SEED TRAYS, WATER TUBE, PRESSURE CONTROL TUBE and SPROUT BARREL throughly with cold or lukewarm water.
d. The WATER BARREL and the MOTOR CHAMBER are attachedtogether. Do not emerge the WATER BARREL into the water when cleaning. Clean the inside of the WATER BARREL with water and wipe the outside of the WATER BARREL with a clean towel. |
 |
 |
|
|
|
|
|
|
